RC-Hangout

Deciding to do up and possibly sell my 600 to fund another project:)

Already ordering parts:)

Checking out best fit. CC BEC ordered .

Why are you ordering a BEC Graham?
It has a 20A BEC built in.

Read that the power draw is too much for the Talon, so most are fitting the external PRO. I have a similar set up on my 550. Also extend the wires to the motor as some were failing there also. Another reason is i read about the internal single wire to the BEC can fail, so external one may stop frying the electronics. Belt and braces if you like:) I also have the Scorpion BUG as well:) The Irish Effect...To be sure,to be sure , to be sure:) Its on Castle website:)

Buddy of mine uses it on his 550L... He hammers on it! No failures. I read all the negative things when I built my 550DFC and opted for the 120HV.. But it may have been overkill... As I said.. Cortez is a smack 3D guy.. Hard! And he hasn't had one go bad..

cml001 wrote:Buddy of mine uses it on his 550L... He hammers on it! No failures. I read all the negative things when I built my 550DFC and opted for the 120HV.. But it may have been overkill... As I said.. Cortez is a smack 3D guy.. Hard! And he hasn't had one go bad..

Good to hear Clay:) but i have already ordered the BEC PRO , I can save it for my KSE 700:)

Right, i went to plug in the Microbeast Plus Pro that i won 2 year ago and i cant get the rudder to change the settings?

I have double checked the TX settings, the travel on the rudder, the wiring to and from the Beast to the receiver. I have even tried a factory reset on the Beast and it wont even do that??

I have sent for the program usb to try that and update the program.

Any ideas??

Select the correct bandwidth?

cml001 wrote:Select the correct bandwidth?

On the Microbeast it sets for Spektrum no problem then I go on to "B" then TX using rudder , nothing. I do however have throttle ?

Got my USB dongle for the Microbeast, plugged it in and updated the firmware to the latest version and it now works:) Possibly the new DX7 Gen2 would not connect on the old firmware.
The Beast did sit in a box in my mancave for over a year:) connected after the update and now i can change the settings with the rudder stick as normal:)
Now to set it up:)

Anyone know if you change the settings on Studio X do you still need to change them with the TX and rudder stick?

Score!