Align Trex 150 DFC Bind Problem:)
Posted: Sat Dec 26, 2015 10:08 pm
Due to continuing bad weather i decided to get my 150 repaired.
One servo was damaged, teeth stripped, so i replaced it. The feathering shaft was bent, so i renewed the feathering and main shaft and renewed the feathering shaft dampers. Quick indoor test to see that the vibration had gone and the servos were working. All was good with my DX6i.
I then decided to set up my DX7 Gen2 for the 150 and thats when my problems started "BIND FAILED"
I tried it first doing the set up via the manual, i then watched Jeff Fassbinder's video on binding, they both failed, i followed them to the letter. Back to the DX6i and it bound first time.
So any ideas??
One servo was damaged, teeth stripped, so i replaced it. The feathering shaft was bent, so i renewed the feathering and main shaft and renewed the feathering shaft dampers. Quick indoor test to see that the vibration had gone and the servos were working. All was good with my DX6i.
I then decided to set up my DX7 Gen2 for the 150 and thats when my problems started "BIND FAILED"
I tried it first doing the set up via the manual, i then watched Jeff Fassbinder's video on binding, they both failed, i followed them to the letter. Back to the DX6i and it bound first time.
So any ideas??