Align Trex 150 DFC Bind Problem:) AGAIN
Posted: Sun Jan 31, 2016 10:42 am
Right, dusted off 150 and tried binding to DX7 Gen2. Impossible!!
Watched videos, read blogs, still no joy:( Then i had a brain wave:) Bound it to the DX6i straight away and it flew:) I then removed the satellite to find it was DSM2, which the new range of TX,s do not support:(
Changed to a DSMX, pressed the set button on the MSR and connected the batterty(Protocol for DSMX on 150), and it bound......but it has a solid red light on the MSR????
Also in the videos it says select "1 servo 90" you cant do that on the DX7 Gen 2 or am i missing something?
Help please:)
Watched videos, read blogs, still no joy:( Then i had a brain wave:) Bound it to the DX6i straight away and it flew:) I then removed the satellite to find it was DSM2, which the new range of TX,s do not support:(
Changed to a DSMX, pressed the set button on the MSR and connected the batterty(Protocol for DSMX on 150), and it bound......but it has a solid red light on the MSR????
Also in the videos it says select "1 servo 90" you cant do that on the DX7 Gen 2 or am i missing something?
Help please:)