Align Trex 450 Pro V2
Posted: Sun Jul 17, 2016 9:50 am
The weather here is really wet, so mushroom picking time:)
I started working on my 450, as i had an issue with the elevator servo. Found an old one and could not remember if it was good or bad. So i stripped it and tested it and could find nothing wrong with it so i fitted it.
I ended up setting up a new model on my TX as i could not get the servos to work together on "I" section on the AR7200BX.
After hours of reversing servo combinations DOH!!! rookie mistake:( i had servos set at 120 instead of normal:)
It now works well:)
Now for a dry spell to fly:(
I started working on my 450, as i had an issue with the elevator servo. Found an old one and could not remember if it was good or bad. So i stripped it and tested it and could find nothing wrong with it so i fitted it.
I ended up setting up a new model on my TX as i could not get the servos to work together on "I" section on the AR7200BX.
After hours of reversing servo combinations DOH!!! rookie mistake:( i had servos set at 120 instead of normal:)
It now works well:)
Now for a dry spell to fly:(