Help with QX90

[DOG]

I have this QX90 flight board that I can't figure why the light is solid red. I need it to be flashing to bind, am I correct?

IMG_1464.JPG (182.12 KiB) Viewed 1790 times

How would I get it to bind to my DX6 gen2?

[pvolcko]

Yeah, usually flashing means it's in bind mode. For these kinds of board it's usually a matter of powering it up without he TX on, it start flashing, then you go through bind on your Tx.


If that isn't what it's doing I'm not sure what you have to do. Maybe you need to plug it into the computer and make sure it is set to the correct transmitter/reciever mode?

[DOG]

Thanks Paul but I can't even get into cleanflight or betaflight with that flight board. I'm giving up on these brush motor quads. I'm going to sell all my New batteries, props, cameras and be done with them. I'm going to try out the brush less one's like this https://www.helidirect.com/tinywhoop/ti ... rsion.html I need something to buzz around the house with, outside of course.

[Lee]

I had problems binding my QX95 board.
I was told to keep trying.
After about 10/15 power cycles, it finally went into bind mode.