RC-Hangout

Posted: **Thu Aug 27, 2015 9:19 pm**

Here are some pics of how I did my lights for easy install and replacement.

One set led, double sided tape, and a piece of foam cut to the size of the gap between the frames.
Stick tape to back of LEDs, and piece of foam.
LEDs fit snugly in the gap. No mess and easy to remove and repair.

: image.jpg (1.8 MiB) Viewed 1483 times

: image.jpg (2 MiB) Viewed 1483 times

: image.jpg (1.45 MiB) Viewed 1483 times

: image.jpg (1.84 MiB) Viewed 1483 times

Posted: **Fri Aug 28, 2015 3:58 am**

thats a great idea Lee.

Posted: **Fri Aug 28, 2015 10:50 am**

Do they move about from time to time since they are "loosely pressure fitted" via the foam?

Posted: **Fri Aug 28, 2015 3:13 pm**

No, they are are tight fit.
The foam, is a high density foam.
I make them slightly thicker than the gap, to get a snug fit.

Posted: **Sun Sep 06, 2015 4:39 pm**

Here they are in action.

: image.jpg (2.13 MiB) Viewed 1441 times

Posted: **Wed Sep 09, 2015 5:53 pm**

Canny that Lee...

Posted: **Sat Sep 12, 2015 8:05 am**

Good idea the side lights:)

RC-Hangout

How I rig my LEDs

How I rig my LEDs

Re: How I rig my LEDs

Re: How I rig my LEDs

Re: How I rig my LEDs

Re: How I rig my LEDs

Re: How I rig my LEDs

Re: How I rig my LEDs