Page 1 of 1
Tbs flight board
Posted: Sun Feb 05, 2017 12:06 am
by DOG
Hey all. Well after plugging in and out the usb cord 2 motor wires came loose. Maybe this was part of the problem with the Xracer
- IMG_1103.JPG (188.27 KiB) Viewed 532 times
Now I'm suppose to solder those wires back on?
Re: Tbs flight board
Posted: Sun Feb 05, 2017 3:17 am
by DOG
Well I decided this a good time then any to learn how to solder this little board
and gave it a try
Now I'm looking for a replacement
I was wondering if this will work
https://www.helidirect.com/tinywhoop/el ... oller.html 
Not this one again.
Re: Tbs flight board
Posted: Sun Feb 05, 2017 9:13 am
by Graham Lawrie
If you have not soldered before, depending on your skills level, i would not practice on a flight board as you can overheat the connection and the trace can fall off.
Yes this could have been the issue or one of your issues, but i would send the picture to TBS to replace it rather than you solder it:)