Page 1 of 1
TBS help again :(
Posted: Tue May 16, 2017 1:02 am
by DOG
I'm having problems again arming and disarming the TBS XRacer. I have the TX endpoints @ 125+/- and the clean flight, not beta flight, the min throttle is 1030 and the max is 1970. I can get everything going in the right direction and binded but arming and disarming is where my problems at. Here's a video and I hope someone can recognize what I'm doing wrong
https://youtu.be/6qXGUZA_Dks
Re: TBS help again :(
Posted: Tue May 16, 2017 4:56 pm
by Graham Lawrie
Off out rock climbing, will take a look when I get back:)
Re: TBS help again :(
Posted: Tue May 16, 2017 9:15 pm
by Graham Lawrie
All the channels should not be on at once:) you need to move the sliders on each channel, so that each position relates to the green highlighted bit and switch position as you move it.
I never have the arm range set.
Re: TBS help again :(
Posted: Wed May 17, 2017 12:22 am
by DOG
Thank you Graham Lawrie for responding back. I hope that you had a great time rock climbing
. I will give that a try and also Derek mention that I need to check my channel assignment. I thank you both for your input but now I'm having problems with the motors starting up and not shutting off til I disconnect the battery
. I just want a brush motor that works with my spektrum DX6. The TBS XRacer and the QX90 haven't been good to me. I would like to fine some sort of set up to put in the TBS XRacer frame and be able to use the motors from the TBS and the QX90. I would like to thank you and Derek for your advice and I will give it a try once I figure out what went wrong again, Lol. I imagine you'll here from me again with another problem
Thanks Again
Re: TBS help again :(
Posted: Wed May 17, 2017 12:48 am
by DOG
Hello again.If I can't get this TBS to work properly, I'm thinking about purchasing this to steal the electronics from and put it in the TBS frame.
https://www.helidirect.com/tinywhoop/ti ... 2-bnf.html their frame is cheesy compare to the XRacer frame. If this doesn't work, I'm giving up on these brush tiny whoop for the time being til I find a decent one or a decent combo.
For some reason I don't have luck with quads. The shuriken 180 that I just purchased and Derek dedicated his time to help me get her going, died too
I'm going to purchase the brother to the 180 this week. I'm ordering the 180 pro and hope I have better luck with the pro. I so glad that my helis are always on stand bye and ready to rock when I want
. They don't let me down beside when I crash
