Msh brain setup help

[treff]

I'm setting up the msh brain and have plugged the servos in the correct ports on the brain and everything works
but my cyclic stick on the left as changed places with the pitch on the right. Is there an easy way to swop these over
in the TX. I'm sure there is but can not remember how to do it. My TX is the dx8.Any help would be appreciated. Thanks

[pvolcko]

Sounds like a mode issue. Not sure how to change it off hand. Does it only do this on one model?

[Lee]

Are you saying,that the cyclic is working on the throttle stick Treff?
When you look at the radio menu, in the Ikon software. Do the stick movements correspond with the sliders?

[treff]

Thanks for the replies guys. Yes very strange the cyclic is on the throttle and vice versa. I will check to see if the stick movements correspond Lee and I will get back.
The Brain is a secondhand unit. I should have reset to factory defaults before I started but forgot.
I've had a look Lee and the elevator and pitch are reversed. All the others are okay. The servo leads are in the correct ports on the brain so I'm a little stuck of
how to put this right. Any ideas most welcome. Cheers

[treff]

Hi all again. I think, think I have found the problem. I believe one or more of the channels is reversed so preventing right operation.
I'm not sure but I think this is the problem. But, which one ? lol Cheers.


UPDATE....................Yes that was the problem a reversed cyclic servo. Whooopeeeeeeee!

[Graham Lawrie]

Nice one Treff:)