Page 1 of 1
Eachine 600mW VTX
Posted: Thu Jul 30, 2015 8:00 pm
by Lee
Put this on my new Mini quad.
I have made some mods.
I removed the Heat shrink, as its super think. Replaced with thin PVC heatshrink.
The VTX gets quite hot, so that didn't help.
I found out, once the heatshrink was removed, that it has output pads for 5V, which was a nice surprise.
I shortened the wire considerably to fit my quad.
- IMG_0096.JPG (2.11 MiB) Viewed 3728 times
- IMG_0098.JPG (3.1 MiB) Viewed 3728 times
Re: Eachine 600mW VTX
Posted: Thu Jul 30, 2015 8:10 pm
by Graham Lawrie
Thats the one i have Lee:) why did you mod it?
Re: Eachine 600mW VTX
Posted: Thu Jul 30, 2015 8:59 pm
by Lee
Just what I said above Graham.
Thinner heat shrink tubing to help cooling.
Shortened wires to help tidy up my mini quad.
I tested the 5V out put with my FPV camera, but didn't work.
Could power the FC and RX from it if necessary.
Re: Eachine 600mW VTX
Posted: Thu Jul 30, 2015 9:02 pm
by Graham Lawrie
Ah me dum:) I have found the Echines very good:)
Re: Eachine 600mW VTX
Posted: Fri Aug 07, 2015 5:43 am
by Tony
Nice mod Lee, you must have a house full of quads now...lol
Re: Eachine 600mW VTX
Posted: Fri Aug 07, 2015 5:58 am
by DOG
With all those quads Lee, I haven't seen the Warp or Goblin in action. You didn't give up on them....or did you?
Re: Eachine 600mW VTX
Posted: Fri Aug 07, 2015 10:06 pm
by Lee
nope Dog.
Its just too dam hot at the moment, and full of tourist, to lug everything out.
Once the beach gets quiet again, and it doesnt take half an hour to find a parking space, i'll be back, end of this month.
Re: Eachine 600mW VTX
Posted: Fri Sep 25, 2015 12:03 am
by Graham Lawrie