dan's rcx 250 flight log LOS and FPV

You fly it, you document it. Tell us the story of the day. As always, video is better!

Moderator: Moderators

Forum rules
Members are encouraged to keep either a single thread for all their flying activities or post a thread per aircraft. If you want to make a one-off thread about a particular flight/event go ahead, but please put a link to that thread in your normal flight thread and vice versa.
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

ive had a play with the roll gains following the lumenier guide lee posted in the multirotor section, And left the pitch and yaw the same as Lee's.

Heres the result, ive hard mounted the camera too show up any wobbles and bobbles.


https://www.youtube.com/watch?v=8ylorXaOzYo
FPV addict.
User avatar
Lee
Moderator
Moderator
Posts: 1824
Joined: Fri Nov 07, 2014 6:16 pm
Location: Tarifa, Spain

Re: dan's rcx 250 flight log LOS and FPV

Post by Lee »

Looked good Dan, what did you change the rolls gain to?
GOBLIN 570------IKON
WARP 360--------IKON
QAV 500----------Open Pilot
RCXH250---------Open Pilot


Citizen #229
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

gain for the roll P 230 (needs dropping a bit) I 530 D 32. going to try 225 220 215 on the P's next.

it was gusty as well lee 5-8mph
FPV addict.
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

ive made a few changes to the quad today, ive been using ppm as the receiver protocol but as h had to remove one of the cables i was unable to use the pot in my tx to change the gains on the fly. so ive spent most of this afternoon making an sbus cable and getting the pot on my tx to work correctly with the cc3d.

Ive also had another read of the lumenier cc3d instructions as well as watch a couple of vids on youtube an it looks like i misunderstood the wiki instructions, so tomorrow im going to start to try to set the gains up again this time, being able to use the pot on my tx should speed the process up no end.
FPV addict.
User avatar
Stambo
Member
Member
Posts: 1349
Joined: Thu Nov 20, 2014 7:13 pm
Location: Whangarei New Zealand

Re: dan's rcx 250 flight log LOS and FPV

Post by Stambo »

Nice flight but man you seem to love shaving them goal posts.
At 1:38 I was sure that was gonna be a hit.
Something I learned while playing race car games many years ago is "watch the gap not the other car".
You seem to go where you look so I have used that in my flying too.
Not always successfully I might add. :)
RCX 250 Minquad FPV addiction
500 X quad FPV/AP platform
450 X quad set up for night flight
Multiple WLToys V911, V949, V959
Taranis, Turnigy 9X
Fatshark Predator, Immersion 5800 Duo
Trex 500 Esky Belt CP V2
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

ive tried another tuning method that i found on the OP website heres a link to the thread http://forums.openpilot.org/topic/39941 ... ds-optune/ this is the calculator to use for 14.10 http://op.thatwebplace.com.au/optune_failsafe.php

i tested the values that i got from the calculator on saturday it was fine with no wind, but this flight there was around a 10-15mph wind and the roll axis didnt like it too much.

https://www.youtube.com/watch?v=BpKjxEGZ-Fk
FPV addict.
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

Due to having another couple of failures on my quad on saturday i have decided to decommission this quad until the fault can be corrected, this isn't the end of my quad/fpv flying as i'm ordering a replacement on friday.

I'm not ordering any type of clone this time, as now i have tryed mini quad fpv and am completely hooked i thought i might as well splash out on something a bit special, i know what your all thinking, Blackout super H, Lumenier QAV250, Flip 250.

None of the above. more info in a week or so.
FPV addict.
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by Graham Lawrie »

What failures? what fault? did i miss something?
Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

there where the initial issues of it throttling up on its own and I had all the motors cut out on me twice on saturday, just stopped mid air. its not a reception issue as ive range tested @ about 200m and my failsafe has been live tested as well both tests were passed.

I has knocked my confidence in this machine, i don't feel that it is safe to fly this machine until the issues have been resolved. so for now its grounded.
FPV addict.
User avatar
KevG
Supporter
Supporter
Posts: 1642
Joined: Fri Nov 07, 2014 4:59 pm
Location: South Wales, UK

Re: dan's rcx 250 flight log LOS and FPV

Post by KevG »

Dan emax kit same as mine on eBay from Portsmouth £111
Minor league Aviator, against gravity which normally wins!

RotoriousFPV quads Micro Rad 3" Gat 4" and Rad 5"
D-Quad Obsession
Yuneec Typhoon H
Taranis Qx7,
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

I've had my orders off my GF after I told her if fell out of the sky. No more Chinese clones!
the frame I'm ordering comes as an ARF. motors, esc naze32 and a battery. So its a complete fresh build.
it's more expensive than the kit you posted kev but it's the design that caught my eye.

Shhh don't say any more you will give it away Dan.
FPV addict.
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by Graham Lawrie »

Come on Dan:) dont keep us in suspenders:) LOL
Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

Ok another clue. It's European designed and made.
FPV addict.
User avatar
Tony
Supporter
Supporter
Posts: 3203
Joined: Thu Nov 06, 2014 3:01 pm
Location: United Kingdom

Re: dan's rcx 250 flight log LOS and FPV

Post by Tony »

Missed out on a lot of flying here Dan, need to catch up. That last flight looked ok. So what's next then I'm wondering......
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

Ha ha. I placed my order for the frame motors, esc's and FC this morning along with a few bits for the build.

This is the kit I've ordered
http://www.fpv-fly.fr/multirotor/porket ... NVEkMseLqB

Most of you will know if from this video (I know I've posted it before)
FPV Racing - Crash Session!!!: http://youtu.be/NsxyV-kgfio
FPV addict.
User avatar
KevG
Supporter
Supporter
Posts: 1642
Joined: Fri Nov 07, 2014 4:59 pm
Location: South Wales, UK

Re: dan's rcx 250 flight log LOS and FPV

Post by KevG »

Nice Dan, good looking quad mate,
Minor league Aviator, against gravity which normally wins!

RotoriousFPV quads Micro Rad 3" Gat 4" and Rad 5"
D-Quad Obsession
Yuneec Typhoon H
Taranis Qx7,
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by Graham Lawrie »

Cool:) Full Naze 32?
Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

No acro Graham. I'm going to try cleanflight I've had a look through it. (i flashed it to my cc3d to have a look at the settings) but couldn't get the sbus to work. So never got to fly it.
It pretty much the same as we all have. For now.
FPV addict.
User avatar
Tony
Supporter
Supporter
Posts: 3203
Joined: Thu Nov 06, 2014 3:01 pm
Location: United Kingdom

Re: dan's rcx 250 flight log LOS and FPV

Post by Tony »

Nice Dan. Are you going to be racing through the woods then too... :o
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
User avatar
danhampson
Site Admin
Site Admin
Posts: 1746
Joined: Thu Nov 06, 2014 2:54 pm
Location: Manchester, United Kingdom
Contact:

Re: dan's rcx 250 flight log LOS and FPV

Post by danhampson »

Maybe with some practice, there's lots of small woods around here.

Here's a closer look at the frame design

Tuto : Porket Frame Building: http://youtu.be/rYn-kPhsHJU
FPV addict.
Post Reply

Return to “Member Flight Logs”