Warp 360 is back in action

Lee · Post by **Lee** » Thu Dec 18, 2014 1:24 pm

Got it put back together after waiting 3 months for some parts to arrive

Shes flying well.
New servo, bearings and links.
I'm a bit rusty though having not flown a heli for a couple of months.

https://www.youtube.com/watch?v=Jfr7L07 ... e=youtu.be

Superbad · Post by **Superbad** » Thu Dec 18, 2014 1:55 pm

Not bad Lee
I Miss my warp some times But it was a little to Hyper for me

Tony · Post by **Tony** » Thu Dec 18, 2014 2:44 pm

Nice one Lee, hope to see more heli flying then mate, can't have this slacking around man...lol

Derek · Post by **Derek** » Thu Dec 18, 2014 8:09 pm

Very cool, Lee! The Warp looks and sounds great!!!

Graham Lawrie · Post by **Graham Lawrie** » Thu Dec 18, 2014 8:25 pm

Nice one Lee:) wish i was that rusty:)lol

KevG · Post by **KevG** » Fri Dec 19, 2014 7:55 pm

Nice Lee, but what cam are you using not liking the fish bowl effect,

Lee · Post by **Lee** » Fri Dec 19, 2014 8:12 pm

Using the Mobius on Wide angle with the B lens.

Well It was short lived. Not sure what happened, but it crashed hard.
Again, very surprised at the little damage.
Only £40 including Blades.
But i but two sets of blades. A cheap test set, and a set of Zeals

Really annoying to have just put it back together and now its dead again.
I was doing a slow inverted circuit, rolled out of it, but it continued to roll and I couldn't stop it???
Went in hard under power.
Blades, boom, Feather shaft.

Tony · Post by **Tony** » Fri Dec 19, 2014 9:41 pm

Nasty Lee, I'm sure you will have it back in the air soon.. When I come down I'll show you how to do that manoeuvre properly mate... Hahaha

Superbad · Post by **Superbad** » Fri Dec 19, 2014 9:46 pm

I would check them servos really good may have one hanging up
Sorry to here about the soon after repair crash

murankar · Post by **murankar** » Fri Dec 19, 2014 11:47 pm

Bad luck or to many crash free 360 flights. I'll say bad luck. If its any consolation I have not flown since may.

KevG · Post by **KevG** » Sat Dec 20, 2014 9:04 am

Lee gutted for ya, pop it back together, and chuck it in the air again,

Post by **pvolcko** » Sun Dec 21, 2014 6:49 am

Oy. That bites. Was it alive when you got to it? Hear any odd beeps or see strange blinking patterns out of the Rx/Sats? Assuming TH didn't work either or did you not get to it in time?

Lee · Post by **Lee** » Sun Dec 21, 2014 9:51 am

Sat was lit, but the DSMX sats don't blink like the DSM2 did.
No beeping.
I'm thinking that, because my batteries are starting to loose there power, the RX had a brownout.
I have had a few issues with Servos not initialising and loosing the bind lately.

Graham Lawrie · Post by **Graham Lawrie** » Mon Dec 22, 2014 10:41 am

unlucky Lee

RC-Hangout

Warp 360 is back in action

Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action

Re: Warp 360 is back in action