La porket flight log.

Post by **danhampson** » Wed Mar 04, 2015 8:22 pm

take your time my friend. get used to flying in the open in acro mode then move on to obstacles, it can get a bit frustrating after the first 6-7 prop changes.

Ive been having a look over La Porket and there seems too be a bit of lateral play in the motor 2 (front right) ive got a couple of spares to hand so im off to install and soldered one up.

I am going to look into a few upgrades for it in the next week or so. Motors being one of them.

Tony · Post by **Tony** » Wed Mar 04, 2015 11:21 pm

wow, that was an awesome crash.... love it....more more...

Stambo · Post by **Stambo** » Thu Mar 05, 2015 12:43 am

Lol, if you had of hit the throttle hard, you may have saved that one.

It seems counter intuitive to throttle up when you are about to hit something but It does work.
Initially my reaction was to throttle down but you soon realise no throttle = no control.

Lee · Post by **Lee** » Thu Mar 05, 2015 9:10 am

Did you damage the light on that crash

Lucky it did get caught up in those wires.

KevG · Post by **KevG** » Thu Mar 05, 2015 1:23 pm

Wow Dan, that looked like a cracker, so where you getting the HQ props from these days

Post by **danhampson** » Thu Mar 05, 2015 2:42 pm

Stambo wrote:Lol, if you had of hit the throttle hard, you may have saved that one.
It seems counter intuitive to throttle up when you are about to hit something but It does work.
Initially my reaction was to throttle down but you soon realise no throttle = no control.

Lol there wasnt alot of throttle left i was at around 85-90% throttle around those posts.

Lee wrote:Did you damage the light on that crash
Lucky it did get caught up in those wires.

There was no damage to the post or the quad, I lost the bottom cover for my camera and it took about 20 mins to find the battery for it.

KevG wrote:Wow Dan, that looked like a cracker, so where you getting the HQ props from these days

All the fun of the fair mate, Ive been getting props from makeitbuildit mate.

Ive put 8 flights on her this morning 4 messing around (high speed runs vtx camera @ 25°) and trying to neaten up flips and rolls. And 4 packs pid tuning, all todays flights have been in 8-10mph wind.

Hers a couple of vids to be going on with i'll post the others when they have uploaded

Pack 1 vtx camera @ 25°
https://www.youtube.com/watch?v=b1E6nYRUX_o

All packs below vtx camera @ 15°
https://www.youtube.com/watch?v=IG4rpKO6E4s

https://www.youtube.com/watch?v=HASl48PsB0k

Post by **danhampson** » Thu Mar 05, 2015 3:39 pm

this is the last of the first 4 packs.

https://www.youtube.com/watch?v=zRNn8a8fOFc

Graham Lawrie · Post by **Graham Lawrie** » Thu Mar 05, 2015 7:48 pm

Brilliant Dan:)

Tony · Post by **Tony** » Fri Mar 06, 2015 8:23 am

Nice smooth flying Dan, always good to watch.

Post by **danhampson** » Fri Mar 06, 2015 11:53 am

so ive talked about some upgrades to Porket. Well ive gone and pulled the trigger on the parts to make La Porket Super Sport.

ive ordered

4x DYS BE1806 2300KV Brushless Motor Black Edition (these motors have been tested and run @ 4s but its not in the specs)
4x DYS 20A ESC SimonK Miniature
Input voltage: 2-4s Lipo
BEC: OPTO
Size(mm)L*W*H: 23*12*4.5
Type: SimonK (not for long)
Hobbywing 3A UBEC
Afro ESC USB Programming Tool
2x ZIPPY Compact 1000mAh 4S 35C Lipo Pack (same weight as the 1300 3s now used)

These parts let me run 3s and 4s at will. Before installation I will be flashing the esc's with BLheli v13.1 this then enables oneshot125 (+ all the other features of KISS esc's).

Im going to keep running the HQ5045's at first ti see how it goes. This setup should be insane on 4s.

Tony · Post by **Tony** » Fri Mar 06, 2015 1:36 pm

You are getting quite a complex piece of kit there Dan

Post by **danhampson** » Fri Mar 06, 2015 2:49 pm

not really tony just an esc and motor change ive just chosen components that will run 4s and oneshot 125.

Lee · Post by **Lee** » Fri Mar 06, 2015 2:54 pm

I have a set of 20A Afro escs I would like to flash to BL heli. Let me know how it goes.

Post by **danhampson** » Fri Mar 06, 2015 6:04 pm

will do Lee.

I found this video on youtube.

4s oneshot porket

https://www.youtube.com/watch?v=JMAm31Y35Fo

Stambo · Post by **Stambo** » Fri Mar 06, 2015 8:02 pm

That goes well but sounds awful.
I could not continue to fly with that noise, I would have to find it and fix it.

Post by **danhampson** » Fri Mar 06, 2015 11:06 pm

ive got a similar rattle, i think its the vtx antenna cover. It comes and goes, either that or its the sj4000 its been crashed a lot.

Tony · Post by **Tony** » Fri Mar 06, 2015 11:18 pm

Wow, that's a fast quad, agree on the noise issue, would do my head in...

Post by **danhampson** » Sat Mar 07, 2015 10:44 am

some of the parts arrived today for the refit. These esc's are tiny i cant believe there 20amp and no cap.

: 20150307_103314[1].jpg (2.03 MiB) Viewed 1430 times

: 20150307_103518[1].jpg (2.04 MiB) Viewed 1430 times

Post by **danhampson** » Sat Mar 07, 2015 11:02 am

I thought that i would record the auw in present config, by the looks of those esc's porket might be going on a crash diet as well as a power increase.

: 20150307_105125[1].jpg (2.22 MiB) Viewed 1429 times

Tony · Post by **Tony** » Sat Mar 07, 2015 11:12 am

Nice little job Dan, I've designed many a switched mode PSU and never used large caps, don't need them these days...

RC-Hangout

La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.

Re: La porket flight log.