Aero Works .90 - 1.20 Yak 54

cml001 · Post by **cml001** » Wed Jul 15, 2015 10:08 am

Kool, post up... We like them moving pictures round here!

cml001 · Post by **cml001** » Sat Jun 11, 2016 4:20 am

Ok... Corrected the AOA of the motor shaft, installed the SmartFly regulator so I can use a dual Lipo power source, installed the fiber optic throttle cut & ensured she gets a spark, tank mounted & new line ran, preliminary throttle setting of end points, Futaba RX wired up... Gotta velcro in the RX & packs... Need to stop by HobbyTown for a carter pin, "Y" harness, & 4 thumb screws... Maiden tomorrow at a club I was invited to.. They asked for a heli demo and I agreed in exchange for setup help on the Yak.... So I'm getting her ready for a maiden... After almost 2yrs of collecting dust! Lol.. Let's do this!

Derek · Post by **Derek** » Sat Jun 11, 2016 5:47 am

Very nice, Clay!

Graham Lawrie · Post by **Graham Lawrie** » Sat Jun 11, 2016 7:32 am

That looks well cool:)

RC-Hangout

Aero Works .90 - 1.20 Yak 54

Re: Aero Works .90 - 1.20 Yak 54

Re: Aero Works .90 - 1.20 Yak 54

Re: Aero Works .90 - 1.20 Yak 54

Re: Aero Works .90 - 1.20 Yak 54