My Quad needs fixing

Discussion, questions, builds, and tutorials on micro and mini (250 and under) size multi-rotors.

Moderator: Moderators

Post Reply
User avatar
Tony
Supporter
Supporter
Posts: 3203
Joined: Thu Nov 06, 2014 3:01 pm
Location: United Kingdom

My Quad needs fixing

Post by Tony »

i seem to have a serious problem with my quad. it should just lift off the deck reasonably straight without cyclic input but mine doesnt. if i dont give it elevator and aileron inputs it will just tip to rear right rotor and the rotor will hit the deck first. once its in the air it seems OK. also during flight it keeps yawing left, i can compensate for some of this with TX trimming but it doesnt cure it.

my suspicions are it needs a new controller board, this has probably been damaged during its dunk in the river at tarifa.

i went fpv flying this morning and that was a total disaster, it ended up inverted twice, this was due to it not taking off in a straight upward direction...
so i think fpv is out for me until i get some training of some kind. i just couldnt figure out where i was, how high i was, nightmare.....

thats my moan for the day... :lol:
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: My Quad needs fixing

Post by Graham Lawrie »

Tony Not sure how your FC works, but i normally re calibrate accelerometer. PID settings can be changed to get rid of Yaw as well. Someone else on here may know your FC board better than me.

Worst case i re set to defaults.

I had to dial out a bit of yaw on my TX:)
Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: My Quad needs fixing

Post by Graham Lawrie »

Another thought is calibrate the esc,s and motors:)
Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: My Quad needs fixing

Post by Graham Lawrie »

Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: My Quad needs fixing

Post by Graham Lawrie »

Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: My Quad needs fixing

Post by Graham Lawrie »

Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
Tony
Supporter
Supporter
Posts: 3203
Joined: Thu Nov 06, 2014 3:01 pm
Location: United Kingdom

Re: My Quad needs fixing

Post by Tony »

Thanks for all that Graham, appreciated. Lee talked me through a total reset and setup, including re-cal of ESC's. But it still didn't work. It's a nightmare really. Takeoff is the worst, ok flying LOS as you can easily compensate, but fpv isn't so easy... Think I'll order the full naze32 board, don't know what else to do really....I don't have a lot of luck with this hobby that's for sure....
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
User avatar
Graham Lawrie
Moderator
Moderator
Posts: 5049
Joined: Thu Nov 06, 2014 7:14 pm
Location: Kinlochleven, Scotland
Contact:

Re: My Quad needs fixing

Post by Graham Lawrie »

None of us do Tony:)
Align 600
Align 550
Align 450 Pro V2 AR7200BX
Align150
Mini-Quad 250/Emax NightHawk /Fossil V2/TBS Disco/Volt
DX6i
MHS Brain/Spartan Vortex/AR7200BX /Microbeast Plus HD
Blade mqx
Scorpion BUG
Fatshark Predator V2 & Mobius




CITIZEN # 521
User avatar
Lee
Moderator
Moderator
Posts: 1824
Joined: Fri Nov 07, 2014 6:16 pm
Location: Tarifa, Spain

Re: My Quad needs fixing

Post by Lee »

I sent you a skype Tony.
I think its a set up issue, as it was flying perfectly, the day I posted it.
Lets do a factory reset on it, and see where we are from there.
GOBLIN 570------IKON
WARP 360--------IKON
QAV 500----------Open Pilot
RCXH250---------Open Pilot


Citizen #229
User avatar
Tony
Supporter
Supporter
Posts: 3203
Joined: Thu Nov 06, 2014 3:01 pm
Location: United Kingdom

Re: My Quad needs fixing

Post by Tony »

Thanks Lee, catch you after your tea..
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
User avatar
wolfman76
Member
Member
Posts: 259
Joined: Sat Nov 08, 2014 12:51 am
Location: Hammond,Indiana
Contact:

Re: My Quad needs fixing

Post by wolfman76 »

my sper quad use to do that but it was a balance issue had to move the battery around to get it centered then it would lift off and hover level flight
custom painted dx8
blueskyrc quad multiwiicopter v4r6 control board
HK500GT w/align dfc head&swash align TT mshbrain fbl controller
T-MAXX 3.3 flysky 3ch tx
GreatPlanes Eagle2 trainer w/62-1/2" wing
Nitroplanes MARIE RedTail p-51 mustang
User avatar
Tony
Supporter
Supporter
Posts: 3203
Joined: Thu Nov 06, 2014 3:01 pm
Location: United Kingdom

Re: My Quad needs fixing

Post by Tony »

That's worth remembering Kyle, thanks mate
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
Post Reply

Return to “Micros and Minis”