Settings for the dx6i and phoenix sim

[Tony]

Can someone give me the best settings for the dx6i to run with the phoenix sim please

Cheers

[Graham Lawrie]

What do you need Tony TX or Phoenix settings:)

[Graham Lawrie]

http://www.rc-help.com/showthread.php?6 ... y-Marius-S

Marius did a brilliant write up on it here Tony:)

[Tony]

Setting for the dx6i in particular Graham, I know there's a setup in the sim to calibrate tx which I've done that's if the tx is correct... I'll look at that now Graham, thanks mate.

[pvolcko]

I set servo limits to 100%, D/R to 100% with 0 Expo on all of ail/ele/rud, pitch curve to a linear diagonal full range (0-100 or -100 to 100 depending on transmitter range on this screen). Throttle curve the same, 0-100 or -100 to 100 depending on transmitter. Then did the calibration screen. After that you can set the D/R and Expo and curves the way you like.

Some recommend setting servo travel limits to full range (-150 to 150 on my transmitter) but that did not work for me all that well. I ended up with pitch going way to positive and negative, cyclic control way too sensitive, etc.