Mini Quad MK 3

[danhampson]

For 6 inch props people are using 2204, 2206 and 2208 motors for the best results. You could try 6in on 1806's but you would have to keep an eye on motors temps.

[Graham Lawrie]

The build begins:)

[Graham Lawrie]

Start positioning parts and the wiring sizing:)

[Graham Lawrie]

I peel back part of the wire and create a hole to fit both ESC positives before soldering:)

[Graham Lawrie]

Then fit the wires and solder:)

[Graham Lawrie]

Heat shrink:)

[Graham Lawrie]

Repeat for the negative wire:)

[Graham Lawrie]

There was a sharp edge where wires could rub:( so i put a piece of silicone wire sheath over:)

[Graham Lawrie]

Nearly there:)

[Graham Lawrie]

Completed and now for the maiden:)

[Graham Lawrie]

http://youtu.be/SqLCMyX2WKQ

Hope you enjoy this as much as i did:)

[Tony]

Wow Graham, you done a great job of the build and the flight was awesome... Superb backdrop.. Where is that place? Looks like a good spot for an overnight stop in the camper...

[Lee]

Very nice Graham

[Graham Lawrie]

Wow Graham, you done a great job of the build and the flight was awesome... Superb backdrop.. Where is that place? Looks like a good spot for an overnight stop in the camper...

2 mile outside my village on the south road:)