So after quite some time I finally redone my power station and added a hitec X4 to it. I re-positioned all my chargers on a piece of wood and drilled a couple of holes through it and used some cable ties to hold my changers and power supply to the wooden backing . I know it is very "ghetto" but it works haha. It now allows me to charge 7 batteries at once although I am limited to a max of 2.2Amps per charger for a 6cell pack which I am actually okay with.
Here is the result:
Damon's charging station setup
Moderator: Moderators
- Kickedd7371
- Member
- Posts: 153
- Joined: Tue Aug 18, 2015 7:28 am
- Location: Western Australia
Damon's charging station setup
- Attachments
-
- charging station.JPG (1.36 MiB) Viewed 2024 times
Re: Damon's charging station setup
A dual powerlab 8 will solve that problem, lol. If it works that's all the matters.
Matthias "URI X3" Urankar | Citizen 00742
Kit: Gaui X3
Servos: BK BL 3001 HV, BL 5005 HV
Motor: Scorpion HK 2520-3500 Kv
TX/RX: Specktrum DX6, VControl
Charger: PowerLabs PL6
Batteries: Pulse Ultra 2250, 35C
Kit: Gaui X3
Servos: BK BL 3001 HV, BL 5005 HV
Motor: Scorpion HK 2520-3500 Kv
TX/RX: Specktrum DX6, VControl
Charger: PowerLabs PL6
Batteries: Pulse Ultra 2250, 35C
Re: Damon's charging station setup
Pretty cool Damon, my only issue would be that of fire precautions.... just incase. With all those turned on and charging lipos it would be a concern of mine.... But a great idea.
Tony - AKA Blackwarrior - nice to be home again
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
Novice pilot
HK450 FBL - Hubsan X4 - RCX H250 FPV Quad with Skyzone goggles..
I reserve the right to be wrong: if proved wrong: I reserve the right to change my mind!!
- Kickedd7371
- Member
- Posts: 153
- Joined: Tue Aug 18, 2015 7:28 am
- Location: Western Australia
Re: Damon's charging station setup
haha cheers mate! I do keep a very close eye on it when they are busy charging, especially when all charger are running. As an extra safety precaution I also don't charge any batteries that I consider to be dodgy (so either very unbalanced or puffed) on this setup. I am considering ways in which I can improve in terms of if a fire were to occur. At the moment I am thinking maybe building small sand bags and installing them above every setup so in the event of a fire the bag should melt and drop sand on it. However then I have to deal with the fact that it is placed vertically. To resolve this I was thinking using some fire resistant material and building open top boxes in which the batteries can be placed therefore if the sand were to drop, it should fill the box thus covering the battery with sand and thus putting out the fire hopefully haha.Tony wrote:Pretty cool Damon, my only issue would be that of fire precautions.... just incase. With all those turned on and charging lipos it would be a concern of mine.... But a great idea.