New Nitro Starter!

[cml001]

Got a new Sullivan starter! Woohoo! This was one of those "I wanna get" things and not a "I need" things... The Align starter I have is fantastic.. Has the heli wand, plane cone cup, & a case.. But I wanted this one from the start when I built the N5C.. Couldn't find one used at the time... Plus on a new build, I was on a serious budget(as if I'm not now.. Lol). Anyhow, Dave had this come into the shop while I was there so I grabbed it! Pretty damn beefy too. 12-24v! I cut the cord short which had battery post clamps & soldered on a EC5 connector. Yes, I know there is a little wire showing... Gonna take the connector off & shrink it later.. Lol.. Didn't think I'd need nor want to lug 24v around attached to it.. So I opted for a 3000mah 4s Glacier pack. Can't wait to use it.

[Graham Lawrie]

Nice pyjamas:) LOL looks well beefy that starter:)

[cml001]

Lol.. They are fleece.. Warm & comfy... A must for winter night sessions in the Lab. Speaking of which.. gonna clean up in the Lab today.. Time to sell some stuff.

[pvolcko]

Try some "liquid electrical tape" on that. Basically latex you can paint on with a brush. I use it a lot on wires when getting shink wrap at it isn't going to work.

http://amzn.com/B000M5PM0G

[cml001]

Ya kno.. I've been meaning to try that.. Thanks for the link! I'll get some!

[Graham Lawrie]

I use it to great stuff and if you dont like it you can peel it off:)