Fossils stuff 280

[KevG]

Ok mate settings in cleanflight then.

First go to ports tab and on the u uart 2 line select the serial rx slider on. Save
Second go in configure tab and select serial rx then scroll down and select spektrum 1024. Save.

Then check to see if you Ave output on rx tab.

[Graham Lawrie]

Not sure if it's relevant, stripped both Lemon rx and found identical marks on signal pins

[danhampson]

Have you feed them 5v ?

[Graham Lawrie]

No Dan, 3v off the Naze 3v pin. Should it be 5v?

[danhampson]

No it should be 3.3v for a spek sat. Just checking with those marks being identical.

[Graham Lawrie]

Yes I thought that strange. Even more so as they worked on my 150?

[Graham Lawrie]

Kev, i have a new Lemon RX and sat same as yours. Still no bind on the sat. My question is why do you need a sat if you have the Lemon RX?

[Graham Lawrie]

Kev, just been reading about the Lemon RX and PPM compatability with Spektrum TX, i have the DX7 Gen 2. They have said there are issues with TAER and AETR? Have you got a wiring diagram?

[KevG]

I bind my Rx to the radio before I put it in the quad, and you could use without the sat if you wanted, for the little extra weight it added I preferred to have the diversity,

Make sure your txt is binding in 11ms otherwise this ppm Rx does not like it,

I selected taer1234 in the naze setup and it was perfect,

[Graham Lawrie]

New DX7 is only 22ms?

[KevG]

Mmmhh just looked at the lemon site and tbh it does not say only 11ms but that's what I had to use,

Make sure you are over 2m away from the Rx with txt when binding though

[Graham Lawrie]

I have a different RX Kev it has the pins out the back and a button?

[KevG]

Post up a pic mate let's have a looksy

[Graham Lawrie]

Post up a pic mate let's have a looksy

Will do Kev tomorrow, dukin an divin between my weekend duties:( Mrs wants quality time as only home at weekends, man cave 100 miles from me when i have time during the week. LOL