Align Trex 600:)

[Graham Lawrie]

Going to upgrade my 600 and think about selling it to get funds for a Goblin......maybe???? Have just bought a Castle ESC 90 as a starting point:)

[Lee]

Castle 90. Which size Gobby?

[Graham Lawrie]

Castle for 600 Lee. Goblin not so sure yet:)

[murankar]

I know that 90 will be cutting it close on a 570, but the 500 it should do fine.

[Graham Lawrie]

What servos for my 600?

I have Futaba S9252 on the 600, but struggling to find some in the UK. I have found one on Ebay, but they are pricey:(

So my question, low budget servos for a 600? Anyone used anything that works well? I am looking at getting 3 for about £100:)

[Derek]

I dunno Graham...beside Align...I'm not sure what else would be considered "budget" without getting into stuff from HK or an equivalent.

[cml001]

I'm still using the Align servos that came in my 550 kit on the the new E5... DS615's I believe they are.. They aren't bad... I like them.

[Graham Lawrie]

I was looking at the 615,s Clay:)

[cml001]

Wish I had the funds to go ahead and buy my preferred servos now.. I'd sell these to u... I do like my MKS! Lol

[murankar]

Bk 7001s are a great value. I am not sure if one over there offers them in a package deal. I got mine as a package then added the tail servo.
Bk llc lists these as follows

7001: $90 USD
7002: $100 USD

7005: $90 USD
7006: $105 USD

[Graham Lawrie]

Wish I had the funds to go ahead and buy my preferred servos now.. I'd sell these to u... I do like my MKS! Lol

[pvolcko]

BK, RJX, Spektrum makes some good budget servos too (though not sure they're still making ones for the larger helis now that Blade cut them from the product line).

[pvolcko]

Now and then I find good deals on Torq servos. Usually on the more expensive side, but if you can find a deal on them you can pick up cyclic servos in the $40-50 a pop range. Hitec can be reasonably priced and good performance too, though they tend to pull more current compared to comparable models from other vendors.