Binding problem :(

[DOG]

I think I posted this in the right area Here's my deli ma. I had a spedix 210 and took all the electronics out of it and installed it in my fossil 210 til I got all new electronics that I wanted for the 210. The Naze32 rev6 finally went that was in the 210 but it's good because now i can install my new electronics . I replace the naze with a Kensun PDB and the omnibus F4 V2 FC with spedix 30a esc and Xnova XTS RM2204/2600KV motors. It's all good til it comes to binding. When I try to bind the rx to my DX6 tx I get the steady rapid flashing orange light in the RX. When i release the bind button to power up the TX to bind the quad, the flashing orange light disappears I've tried different ways to bind it. I even created a new model and still it wont bind. I switch RX, which is a dsmx rx,with another dsmx rx and still the same thing. When I release the bind button the flashing orange light disappears. I'm clueless right now and was wondering if anyone might have any idea what could be wrong.

[Graham Lawrie]

Try binding the rx on its own first or to something else. Then fit it to what you want to bind it to if that makes sense?

[DOG]

Thanks you Graham. After letting the quad and everything alone all night. When I first tried binding the quad this morning, she had no problem binding This afternoon when I went to bind the quad again, I took off the Rx to try the other RX out, nothing happen again . This time the orange light came on but before i can grab the radio to bind, the orange light just slowly faded away. I went back to the first RX and again nothing. So I'm back to square one