Emax nighthawk 250 build thread

[CrazyCooter75]

Looking good! You did a great job on making the wiring look clean. Looking at these builds makes me want to dust off my 240 quad!

[Graham Lawrie]

Looking good! You did a great job on making the wiring look clean. Looking at these builds makes me want to dust off my 240 quad!

Dust dust dust:)

[Lee]

Looks good Kev.
Waiting on new screws for mine, then i'll have a go at making it neat.

[KevG]

Thanks Lee, have you shortened the camera to vtx lead before or will it cause issues, also taking the grey cover off it,

[Lee]

Yeh I have shortened the leads before, but not the ones with the RF cover.

[KevG]

Well a few alterations to what I had,

First, I had a freind print me a camera mount,

image.jpg (614.98 KiB) Viewed 3666 times

I have added a switch into the vtx power line, as I wanted to run direct off my PDB but not want the vtx on constantly

image.jpg (681.32 KiB) Viewed 3666 times

So here is the finished article, I think I got it as clean as I can, for now anyway,

image.jpg (804.97 KiB) Viewed 3666 times

image.jpg (743.11 KiB) Viewed 3666 times

And how good do these antenna look, clean and nice,

image.jpg (813.41 KiB) Viewed 3666 times

[Graham Lawrie]

I love my antennas:) nice Kev:)

[Tony]

Very nice build Kev...

[Lee]

Looking clean Kev

[KevG]

Well I have gone to the dark side, and put an ORX R615x on the bird, not sure yet on mounting but have gone for this due to being able to run PPM input, one wire, can't fault it,

Oh and it being 3.5g decased or 9g cased helps plus so many less wires and plugs,

Some work to do later one thinks,

Pics to follow

[Graham Lawrie]

I had one of them on mine Kev:) cant fault it:) worked very well:)

[cml001]

Clean build bruh! Looks good!

[KevG]

Well as promised here is a few pics, of what I have been up to in the last few days,

First I changed out the RX for the ORX R615x just to be able to run PPM

image.jpg (800.16 KiB) Viewed 3622 times

And you can see in the picture the new switch I put in for my VRx I was not happy with the small toggle switch I had used,

I used one of the guys in our engineering department and had him draw up a rear bumper for the sole purpose of mounting a longer string of led's, this was the first try and it turned out not bad,

image.jpg (585.41 KiB) Viewed 3622 times

image.jpg (723.33 KiB) Viewed 3622 times

And the show of nice bright led's

image.jpg (416.44 KiB) Viewed 3622 times

Man I thought my white ones were bright,

image.jpg (442.17 KiB) Viewed 3622 times

[Graham Lawrie]

Brilliant job Kev:) love the rear bumper:)

[KevG]

Yeah it's 3d printed, my measurements and design, if anyone wants te STL file to print one just drop me a bell,

[cml001]

Sweet!